Amazone GreenDrill 200-E - 7-Pin Tractor Signal Socket; Working Position Sensor Connection

GreenDrill 5.2 on-board computer
56
GreenDrill BAH0054-4 02.13
7.7.3.1 7-pin tractor signal socket
The tractor
is equipped with the 7-pin tractor signal
socket
supplies the required 3 signals
Signal cable (1) connects the on-board computer
(12 -pin signal connector) to the tractor socket
(7 -pin socket).
The cable carries 3 signals (see Chapter "ISO
11786 Signal") from the tractor to the on-board
computer.
actual travel speed [km/h]
position of the work sensor
(e.g. the lifting gear signal).
7.7.3.2 Working position sensor connection
Requirement:
The tractor supplies the travel speed signal [km/h] via
the 7-pin tractor signal socket.
the tractor does not provide a "Work sensor position" signal.
The work position sensor is subsequently installed.
The splitter (A) connects
the on-board computer (12-pin)
to the tractor socket (7 -pin)
to the working position sensor
Interface (1): on-board computer
Interface (2): tractor socket (7 -pin)
Interface (3): work sensor.
Interface (2) transmits the travel speed signals (km/h).
Interface (2) transmits the "Position of the work sensors" signal [e.g.
lifting gear signal])