H-1.601. 00137-B3.0
Page 16 of 81
2 Alarm Set alarm volume and way.
3 System Set screen brightness, unit, desktop style,
waveform style, voice, and ETCO2.
4 Time Set system time of equipment
5 Calibration Calibrate equipment's air proportion valve,
oxygen proportion valve and PEEP
proportion valve.
6 About Host View the equipment's main software version
No. and control software version No.
3.2.1 Full Ventilation Parameters Setting
You can set ventilation control parameters based on patient's respiratory
physiological characteristics（As shown below）.
The setting procedure is given below：
1. Select Ventilation button by using the navigation knob to pop up
ventilation setting window.
2. Select the ventilation parameter value to be changed by pressing
navigation knob or directly clicking on it.
3. Modify the selected ventilation parameter value and press navigation
knob again to confirm the modification.
4. Repeat Steps 2 and 3 to modify other parameter limits.
5. Exit from the main menu by clicking on "X" button or pressing Main
Menu button again, Cancel parameter modification.
Adapter disconnencted!!
CPR
VentilateCPREventsAlarm
tidal volume
I/E
Freq
PEEP
Fio2
FIGURE 7 Ventilate
To Next Page
Loading...