27
XBLUE- 78GA3/XBLUE- 78VA3
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Advanced BIOS Features
Advanced Settings
Help Item
WARNING: Setting wrong values in below sections
May cause system to malfunction
CPU Configuration Press Enter
Hard Disk Drivers Press Enter
Removable Drivers Press Enter
Quick Boot Enabled
2
nd
Boot Device HDD:PM-WDC WD800
3
rd
Boot Device 1
st
Floopy Driver
Boot up Num-Lock On
ACPI APIC Support Enabled
MPS Revision Enabled
Quiet Boot Disabled
Configure CPU
↑↓→←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
Removable Drives
Use this item to specify the boot device priority sequence from available removable drives.
Quick Boot
Allows BIOS to skip certain tests while booting. This will decrease the needed to boot the
system.
1
st
/2
nd
/3
rd
Boot Device/3
rd
Boot Device
Specify the boot sequence from the available devices. A device enclosed in parenthesis has
been disabled in corresponding type menu.
Boot Up NumLock Status
The default value is On.
On
(default)
Keypad is numeric keys.
Off
Keypad is arrow keys.
ACPI APIC Support
Include ACPI APIC table pointer to RSDT pointer list.
MPS Revision
This option is only valid for multiprocessor motherboards as it specifies the version of the
Multiprocessor Specification (MPS) that the motherboard will use.
Quiet Boot
The optional settings are Enabled and Disable.
Disabled: Display normal POST message.
Enabled: Displays OME logo instead of POST message.
To Next Page
Loading...
Need help?
General
