35
The optional settings are: IrDA(1.6 ns) and IrDA (3/16 bit).
IrDA Duplex Mode/Serial Port 2 Mode
This item allows BIOS to select full or half duplex for serial port 2(IR Mode).The optional
settings are: Full Duplex; Half Duplex.
IrTX Pin Select
The optional settings are: Normal and Inverse.
This item allows BIOS to select transmit pin in a normal condition or inverse the IRTX(IR
Mode).
IrRX Pin Select
The optional settings are: Normal and Inverse.
This item allows BIOS to select receiver pin in normal condition or inverse the IRRX(IR
mode).
IRTX to RX Delay Select
The optional settings are: No Delay and Reception Delay.
This item allows BIOS to select IR from RX to TX 4 characters time delay for serial port2(IR
mode)
IRRX to TX Delay Select
The optional settings are: No Delay and Transmission Delay.
3-8 Power Management Setup
The Power Management Setup allows you to configure your system to most effectively save
energy saving while operating in a manner consistent with your own style of computer use.
XBLUE- 77A3
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Power Management Setup
Power Management Feature
Help Item
Power Management/APM Enabled
Suspend Time Out Disabled
Power Button Mode On/Off
Video Power Down Mode Suspend
Hard Disk Power Down Mode Suspend
Hard Disk Time Out (Minute) Disabled
RTC Resume Disabled
Disable/Enable
RTC to generate a wake event
↑↓→←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Discard Changes F6:Standard Settings F7: Optimized Settings
XBLUE- 78GA3/XBLUE- 78VA3
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Power Management Setup
Power Management Feature
Help Item
Power Management/APM Enabled
Suspend Time Out Disabled
Power Button Mode On/Off
Video Power Down Mode Suspend
Hard Disk Power Down Mode Suspend
Hard Disk Time Out (Minute) Disabled
Restore on AC Power Loss Disabled
RTC Resume Disabled
Disable/Enable
RTC to generate a wake event
↑↓→←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults