Ametek 3050 Series

To Next Page

To Previous Page

3-16 | 3050-SLR Moisture Analyzer

Figure 3-15.

RS-485 to RS-232 Conversion for Host PC

Notes:

1. Converter and Power Supply are not suitable for use in hazardous areas.

2. Refer to chapter 6 for replacement part numbers.

Main Page

Analyzer Serial Number Location3
Table of Contents4
Safety Notes8
Electrical Safety8
Grounding8
Environmental Information (WEEE)9
3050 Slr Moisture Analyzer13
Overview13
Controller Communication14
Veri Ication15
Gas Flow15
Internal Timing15
Calculation of Dewpoint Values for Hydrocarbon Streams16
Specifications19
Operating Environment19
Approvals and Certi Ications19
Ranges20
Outputs20
Data20
Alarms/Alerts20
Lower Detectable Limit20
Sensitivity20
Accuracy20
Reproducibility20
Moisture Generator Value20
Instrument Air Requirements21
Back Pressure Regulator Requirements (if Purchased)21
Sample Inlet Pressure Requirement21
Exhaust Pressure21
Minimum Differential Pressure21
Sample Flow Requirement21
Inlet Gas Temperature21
Power Requirements22
Minimum PC Requirements for Software22
Dimensions22
Net Weight22
Installation and Start up25
Unpacking and Inspection25
Sample System Space Requirements25
Power Requirements25
System Tubing25
Dry Reference Gas25
Sample Gases26
Sample Pressure and Temperature Requirements26
Mechanical Installation28
Electrical Connections29
Analyzer Start-Up35
Interconnect Wiring36
4-20 Ma Output Wiring37
RS232 Wiring38
RS485 Cables39
Status Leds and Alarms41
User Interface43
3050-SLR Moisture con Igurator Software43
Con Igurator Software Installation43
Con Iguring the 305044
General Tab44
PC Communications44
Communication Protocol45
Saving Your Settings45
Live Data46
Con Iguring Multiple Analyzers47
Setup Tab49
Sensor Saver Check Box50
Gas Saver Check Box50
4-20 Ma Output50
Alarm Output50
Set Clock51
Set Dryer Production Code52
Scheduled Zero53
Saving Your Settings53
Flow Adjust56
Test Alarms57
Test Ma Output57
Remote Verification59
Replacement Parts and Maintenance61
Glossary of Terms63
Modbus Communication Interface67
Overview67
Analyzer Modbus Interface Parameters69
Modbus Address69
Communication Parameters69
Modbus Functions70
Exception Code70
Holding Registers71
ID/Status Information78
Example 1: Alarm Enable80
Example 2: Setting the High-Alarm Limit81
Example 3: Setting the Low-Alarm Limit81
Example 4: Enabling "Hold During Verify81
Example 5: Setting the High-End of the Analog Output81
Example 6: Setting the Low-End of the Analog Output82
Example 7: Switching to "Sensor-Saver" Mode82
Example 8: Switch to Dewpoint Readings82
Example 9: Selecting a Sample Gas83
Example 10: Setting Veri Ication Schedule83

Ametek 3050 Series

Table of Contents

Related product manuals