Ametek 3050 Series

User Interface | 4-1

NOTE
USER INTERFACE
3050-SLR Moisture Conigurator Software
The Conigurator software provides a graphical user interface to set up parameters for ei-
ther a single analyzer or multiple analyzers.
Though you can set and view parameters for multiple analyzers using the Conigu-
rator software, you can only work with one analyzer at any time.
Conigurator Software Installation
1. Insert the Setup Disk 1 in your CD disk drive.
2. The installation program should begin to run immediately. If it does not
start automatically, click RUN... from the Windows Start menu. Type the
drive letter, followed by a colon ( : ) and a backslash (\) and the word
“setup.exe” (a:\setup.exe) and click OK to start the installation program.
3. Follow the instructions on the subsequent screens to complete the
installation. When you get to the Setup Complete screen, click Finish to
complete the installation. The default location for the 3050 software is in
the AMETEK folder.
Coniguration installation disk 2 may not be requested depending on prior conigu-
rator installations.
Turn off all power saving modes.

NOTE

NOTE