Ametek BROOKFIELD CT3 User Manual

AMETEK Brookeld Page 51 Manual No. M08-372-F1116
ACCESSORIES FOR FIXTURE BASE TABLE
TA-BT-KIT FIXTURE BASE TABLE
Rectangular base table with removable insert, which is used as a test surface. All
accessories listed below mount into this table when the insert is removed. Pair of
T-Bolts for securing the table are included. Four sets of extension legs (1, 1.5, 2
& 4 Inches) are supplied. Extra extension legs may be purchased separately.
TA-BT-3KY Set of four 1 inch table leg extensions
TA-BT-2KY Set of four 1.5 inch table leg extensions
TA-BT-7KY Set of four 2 inch table leg extensions
TA-BT-8KY Set of four 4 inch table leg extensions
TA-BT-6KY Set of two thumbscrews for base table insert
ALL ACCESSORY FIXTURES BELOW MOUNT ONTO FIXTURE BASE TABLE
TA-AACC21 AACC RECOMMENDED 21mm DIAMETER PROBE
Aluminum Cylinder, 21mm D and 40mm L. Requires Fixture Table Base TA-
BT-KIT.
TA-AACC36 AACC SPEC PROBE (36mm)
Thisprobeisusedformeasuringbreadrmnessandperformingtextureprole
analysis (TPA). Requires Fixture Table Base TA-BT-KIT.
TA-BLS BILAYER SHEAR TEST FIXTURE
Thisxtureusesaguillotinebladetoseparateabilayertabletwhilemeasuring
shear strength. Requires Fixture Base Table TA-BT-KIT.
TA-BPS BLISTER PACK SUPPORT TEST FIXTURE
Thisxtureisusedtomeasuretheforcerequiredtoremovethetabletfromits
blister pack. Requires Fixture Base Table TA-BT-KIT.
TA-CEF CHEESE EXTENSIBILITY FIXTURE
Thisxture measurestheextensibilityofasmaple,suchasmolten cheese,to
break point.
TA-CJ CONFECTIONERY JIG
This xture is used for holding candies and similar products for penetration
testing. Requires Fixture Base Table TA-BT-KIT. Consists of bases and top
plates with holes 4mm, 8mm and 12mm in diameter to allow through penetration
of samples with probes slightly smaller than holes. One blank plate (no hole) is
also included to serve as a test surface when needed.
TA-CKA CRAFT KNIFE ADAPTER
This adapter cuts cleanly into and through material with minimum deformation
of the sample. Requires Fixture Base Table TA-BT-KIT.
TA-CLT001 CAPSULE LOOP TENSILE TEST FIXTURE
Thisxtureisusedtomeasuretheforcerequiredtosplitonhalfofahardgel
capsule. Requires Fixture Base Table TA-BT-KIT.

Ametek BROOKFIELD CT3 Specifications

General

Brand	Ametek
Model	BROOKFIELD CT3
Category	Measuring Instruments
Language	English