Ametek BROOKFIELD CT3

AMETEK Brookeld Page 52 Manual No. M08-372-F1116
TA-CSF CIRCULAR SUPPORT FIXTURE
Thisxtureprovidessupportforroundsamplesandretainsanypotentialuid
expressed during the test. Requires Fixture Table Base TA-BT-KIT.
TA-CTP COMPRESSION TOP PLATE
Rectangular plate 150mm X 100mm, used for compressing large samples.
Fixture Base Table TA-BT-KIT is normally used to support sample while testing
with this large compression plate.
TA-DE DOUGH EXTENSIBILITY JIG
Thisxtureisusedforholdingasheetofrawdoughoratbreadtomeasurethe
breaking point of the stretched sample. Consisting of 2 aluminum plates, one
plate with 25.4mm hole and the other with 38.1mm hole complete with upper
xingplatestoholddiscofatsample.UsedwithTA18*andTA43*probes
respectively. Requires Fixture Table Base TA-BT-KIT.
TA-DEC DUAL EXTRUSION CELL
The Dual Extrusion Cell is used for either forward or back extrusion of fruit puree,
pudding, yogurt or similar products. Test cell is cylinder 40mm in diameter and
50mm depth. Forward extrusion forces a semi-solid sample through an outlet of
known geometry. Complete with 4 plungers of 34mm, 36mm, 38mm and 40mm
in diameter and interchangeable base plates with apertures of 8mm, 6mm, 4mm,
2mm and one blank. Requires Fixture Base Table TA-BT-KIT.
TA-DGF DUAL GRIP FIXTURE
Thesearemultipurposegeneraljigsfortensiletypetesting.Thexturesutilize
auniversalttingenabling360ºrotationforcomprehensivetestconguration.
The25mmwidegripsarettedwithrubberinsertstomaximisecontactadhesion
with sample and are capable of holding rectangular samples up to 5mm thick.
Each grip clamps from both sides of sample with two opposing thumbscrews.
Attaches to slot in CT3 base. Does not require any base table.
TA-DSJ DOUGH STICKINESS JIG
Thisxtureisusedformeasuringdoughstickinessasastandardtest;importantfor
processing raw dough. Requires Fixture Base Table TA-BT-KIT and TA3/1000
or TA11/1000* probe.
TA-EP EYE PENCIL TEST FIXTURE
Thisxture measuresthehardnessofcosmeticpenciltipsforeye-orlip-ling
products and can also be used for artistic type pencil tips. Requires Fixture Base
Table TA-BT-KIT.
TA-FMBRA FMBRA STANDARD DOUGH POT SET
This set is used for preparing dough samplesand measuringdough rmness.
Thesetcomprisesoftwotestcellsandtwoplungers:Anaerationplungerand
a compacting plunger. A known weight of sample is placed in the pot and the
aeration plunger is used to remove air pockets through gentle rotation. The dough
isthenassessedforrmnessusingaTA416mmØstainlesssteelprobe.Includes
Dough Aerator, Dough Compactor & 2 Containers.