123312 03 17-08-2004 33
4.6.2 Adjusting the max-temperature
Press
or to set the max-temperature in steps of
0.1°C or 0.1°F:
°C
If the current set-temperature is higher than the new max-
temperature, you will need to adjust the set-temperature. The
instrument will immediately begin to cool (if required) as soon
as the new max-temperature is accepted.
Press
to accept your selection.
If you wish to exit SETUP, simply press
.
4.6.3 Adjusting the SWITCH TEST slope rate
Press
or to set the SWITCH TEST slope rate to a
temperature between 0.1°C and 9.9°C in steps of 0.1°C (if
your chosen temperature unit is °F, the range will change to
between 0.1°F and 9.9°F in steps of 0.1°F):
°C
Press
to accept your selection.
To Next Page
Loading...
Need help?
General
