38 17-08-2004 123312 03
6.0 Errors
Warning
The calibrator must be switched off before any attempt to
service the instrument is made.
Note…
Ametek Denmark’s liability ceases if:
• parts are replaced/repaired using spare parts which are
not identical to those recommended by the manufacturer.
• non-original parts are used in any way when operating
the instrument.
Ametek Denmark’s liability is restricted to errors which
originated from the factory.
If the calibrator detects an error during operation, the instrument will
terminate all functions and display an error code:
Likely cause: Defective RTD-sensor or excessively high
temperature measured by the instrument’s internal
sensor.
Solution: The calibrator should be returned to the
manufacturer for service.
Likely cause: The calibration coefficients have not been accepted.
Solution: Try again. If the error message returns, the
calibrator should be returned to the manufacturer
for service.
To Next Page
Loading...
Need help?
General
