123312 03 17-08-2004 35
4.7 Simulation/training
Hold down the
and buttons while you switch on the
calibrator.
The instrument will display the following screen:
The instrument will then revert to the standard display.
The calibrator’s simulation mode is used to train personnel in the use
of the instrument, etc. The simulation setting differs from the standard
setting as follows:
• The instrument will not actually heat up or cool down the well.
• The heating and cooling processes are simulated at around 10
times the normal speed of these operations.
The calibrator will remain in simulation mode until it is switched off.
To Next Page
Loading...
Need help?
General
