123312 03 17-08-2004 41
Remove both fuses and insert two new fuses. These must be
identical and should correspond to the line voltage.
• ITC-155: 115V, 2AT = 105014 / 230V, 1AT = 105007
• ITC-320/650: 115V, 10AF = 60B302 / 230V, 5AF = 60B301
If the fuses blow immediately after you have replaced them,
the calibrator should be returned to the manufacturer for
service.
Slide the fuse box into place with the correct voltage turning
upwards.
7.1 Returning the calibrator for service
When returning the calibrator to the manufacturer for service, please
enclose a fully completed service information form. Simply copy the
form on the following page and fill in the required information.
The calibrator should be returned in the original packing.
To Next Page
Loading...
Need help?
General
