6 17-08-2004 123312 03
2.0 Safety instructions
Read this manual carefully before
using the instrument!
Please follow the instructions and procedures
described in this manual. They are designed to
allow you to get the most out of your calibrator and
avoid any personal injuries and/or damage to the
instrument.
Warning……
About the use:
• The calibrator must not be used for any purposes
other than those described in this manual.
• The calibrator is designed for interior use only and
should not be used in risk-prone areas, where
vapour or gas leaks, etc. may constitute an
explosives hazard.
• The calibrator must be kept clear within an area of
20 cm on all sides and 1 metre above the calibrator.
• Never use heat transfer fluids such as silicone, oil,
paste, etc.
These fluids may penetrate the calibrator and cause
damage or create poisonous fumes.
• The calibrator must be switched off before any
attempt to service the instrument is made.
• When cleaning the well, REMEMBER, wear goggles
when using compressed air!
About the frontpanel:
• The switch-test connectors, on the front panel of the
calibrator, must NEVER be connected to a voltage
source.
• Thermostats must not be connected to any other
voltage source during a test.
To Next Page
Loading...
Need help?
General
