49ARX 23-2 T4i, ARX 26-2 T4i
OPERATING MANUAL
Travel control – right (standard) (11)
The travel control is used to set the engine speed, the parking
brake, forward/reverse direction and the travel speed of the ma-
chine. Direction and speed of machine travel is controlled by
shifting the control from zero position (0) forward or backward.
The travel speed corresponds to the displacement of the travel
control at the set speed gear. The travel control is xed in the set
position except for the zero position (0).
The travel control can activate the so-called panic response
(Chapter 2.7.2).
Shifting the control to the neutral position (N) stops the machi-
ne – the parking brake is not engaged!
If you leave the travel lever in the neutral position (N),
it is possible that the machine will move from the slope
due to leakages of the hydraulic system.
The parking brake position (P) is indicated by lighting up of the
parking brake indicator lamp.
The travel control is tted with vibration, drum sprinkling, edge
cutter (up/down) and edge cutter sprinkling switches.
P – Parking brake – parking brake of the machine enabled
N – Neutral – the machine is not braked
0 – Zero position
F – Forward travel
R – Reverse travel
Travel control – left (optional)
The travel control is used to set the engine speed, the parking
brake, forward/reverse direction and the travel speed of the ma-
chine. Direction and speed of machine travel is controlled by
shifting the control from zero position (0) forward or backward.
The travel speed corresponds to the displacement of the travel
control at the set speed gear. The travel control is xed in the set
position except for the zero position (0).
The travel control can activate the so-called panic response
(Chapter 2.7.2).
Shifting the control to the neutral position (N) stops the machi-
ne – the parking brake is not engaged!
If you leave the travel lever in the neutral position (N),
it is possible that the machine will move from the slope
due to leakages of the hydraulic system.
The parking brake position (P) is indicated by lighting up of the
parking brake indicator lamp.
The travel control is tted with vibration and drum sprinkling.
P – Parking brake – parking brake of the machine enabled
N – Neutral – the machine is not braked
0 – Zero position
F – Forward travel
R – Reverse travel
Note
If requested by the customer, the machine can be equipped
with the second travel control (11) placed on the left armrest.
However, only one of travel controls (11) may remain active.
For the machine travel using one of the controls (the active one),
the inactive travel control must be set to the parking brake po-
sition (P). If the inactive control is deected from the parking
brake position (P), the machine will stop. When the machine is
stopped, move both of the travel controls (11) to the parking
brake position (P) and then select the driving direction on the
active travel control (11).
To Next Page
Loading...
