142 ARX 23-2 T4i, ARX 26-2 T4i
3.6 Lubrication and maintenance operations
3.6.22 Engine oil change
Carry out for the rst time after 50 hours
Drain the oil after the operation is nished immediately
after the coolant has been cold down to 60°C (140°F), or
warm up the engine during operation until the coolant
temperature reaches 60°C (140°F).
The engine oil drain plug is on the left side in front between the
front and rear frame of the machine.
Turn the machine to the right to get better access to the drain
plug.
The total volume of oil in the engine is 7 litres (1.85 US gal).
Remove the drain plug and let the oil drain out.
Remount the plug.
Clean the surface around the head of the oil lter. Remove the
lter. Clean the seating surface for the lter gasket.
Lubricate the gasket with oil.
Mount the new lter.
Do not overtighten the lters to prevent damage to the
thread and gasket.
Engine oil lter
Order number: 1504183
To Next Page
Loading...
