Ammann ARX 23-2 - 2.3 Preservation and storage

31ARX 23-2 T4i, ARX 26-2 T4i
Sig. 1
STOP
Sig. 10
Sig. 11
OPERATING MANUAL
2.1.6 Hand signals
Signals given by an assistant operator if the operator cannot see
the travelling or working area or work devices of the machine.
The following principles must be observed:
• For communication purposes, only alimited number of sig-
nals must be used.
• The signals must be clearly distinguishable to prevent any
misunderstanding.
• Hand signals can only be used when ambient conditions al-
low clear communication between persons.
• Hand signals must be as similar as possible to intuitive
movements.
• Single-handed signals can be done with any hand.
SIGNALS FOR GENERAL COMMANDS
Engine start
Engine OFF
Stop