TPI Configuration and Usage
25
AXB-TPI/3 Touch Panel Interface 3
window. You are setting up the touch panel to act as the interface for the TPI/3 by displaying
the VGA signal coming in from the TPI/3.
9. After pressing
VGA PAGE the background image now reflects the incoming signal from the
AXB-TPI/3.
10. Press
EDIT > BUTTON > DELETE to remove the MAIN and SETUP buttons from displaying
on-screen.
11. Press
EDIT > BUTTON > ADD to add a transparent button somewhere on the screen so there is
a means of accessing the SETUP menu for the color graphic touch panel. This is a hidden
button an should be placed in a location on the screen that will not overlap with any other
buttons.
12. Use the AXlink cable to communicate with the TPI/3 and touch panel through
Send_Commands.
13. Configure the TPI/3 to use the appropriate mouse driver for the touch panel by entering:
14. Configure the touch panel to control the activity on the TPI/3 by entering:
Calibrate the TPI/3 by entering:
Refer to the Setting Up AXlink Communication from Master to the TPI/3 section on
page 17 for more detailed setup and configuration instructions.
Send_Command, <TPI/3 device number>,"’@MOU 8012’"
Sets the TPI/3 to use the Elo IntelliTouch drivers with the touch panel.
PRGM EX. 18
Send_Command, <TPI/3 device number>,"’@MOU 8000’"
Sets the touch panel to use the Elo IntelliTouch drivers and has the TPI/3 respond to touches produced by
the touch panel.
PRGM EX. 19
Send_Command, <TPI/3 device number>,"’calibrate’"
This command instructs the TPI/3 to begin the calibration mode and receive its calibration input through
the touch panel that is now configured to work with the output from the TPI/3.
PRGM EX. 20
To Next Page
Loading...
