Designing Touch Panel Pages
29
AXB-TPI/3 Touch Panel Interface 3
4. Press EDITOR to enable Edit mode. The EDITOR button is highlighted in the Protected Setup
page when enabled, as shown in FIG. 11.
5. Press
EXIT to close the Protected Setup page and return to the Setup page (now in Edit mode).
6. Press
EXIT again to return to the Main page. The EDIT button appears at the top of the page
indicating Edit mode is active.
7. Press
EDIT to open the Edit bar. The BUTTON and PAGE options, in the Edit bar (FIG. 12), are
used to design and modify button and page settings.
FIG. 10 Setup page
FIG. 11 Protected Setup page with the active EDITOR button
FIG. 12 Main page with Edit bar
Edit bar
To Next Page
Loading...
