To Next Page

To Previous Page

Modero S Series G4 Touch Panels

Modero S Series G4 Touch Panels Instruction Manual

Cleaning the Touch Overlay and Case

When cleaning the device, do not directly spray the device with cleaning fluid. Instead, spray the cloth and

then apply the cloth to the touch screen.

Do NOT use abrasives of any type to clean the device, as abrasives may permanently damage or remove the

device’s finish.

If the calibration was improperly set and you cannot return to the Calibrate

page (through the panel’s firmware); this firmware page can be accessed via G4

WebControl by navigating to the Protected Setup page and pressing the Calibrate

button through the VNC window.

This action causes the panel to go to the Calibrate page seen above, where

recalibration of the actual touch panel can be performed again using the above

procedures.

A mouse can be plugged into the USB port (on panels that have access to it) and

used to navigate back to the Calibration page. The process of pushing the button

could also be repeated as necessary.

Other manuals for AMX MST-1001

Questions and Answers:

Need help?

Do you have a question about the AMX MST-1001 and is the answer not in the manual?

General

Aspect ratio	16:9
Screen shape	Flat
Display diagonal	10 \
Touchscreen type	Tabletop
Display brightness	350 cd/m²
Display resolution	1280 x 800 pixels
Display technology	LED
Touchscreen technology	Resistive
Viewable size diagonal	256 mm
Contrast ratio (typical)	800:1
Display number of colors	16.78 million colors
Product color	Black
Ethernet LAN (RJ-45) ports	1
Display viewable area (HxV)	136 x 217 mm
Power supply type	DC
Power consumption (standby)	4.5 W
Power consumption (typical)	7.5 W
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 85 %
Operating relative humidity (H-H)	20 - 85 %
Wall mountable	No
HDMI ports quantity	0
Graphics card	AMX G4
Internal memory	512 MB
Internal memory type	DDR
RMS rated power	1.5 W