AMX SC-N8012 User Manual

Chapter 3: Configuration Options
17
N-Command User Manual
Recording Settings
The section of the NVR Controls page shown in Figure 12 is displayed when you click the Recording link. Options are described in
Tabl e 7
.
FIG. 12
Recording Settings
TABLE 7 NVR Controls Page: Recording Settings
Option Description Notes
Description field Enter a description for this recording.
Time (min) field Limit recording time by entering a duration (in
minutes).
How this limit is enforced depends on whether or not
the Continuous checkbox is enabled.
Record Vid Choose from a list of compatible Encoders to choose to
record from.
These fields are dependent on the chosen Mode. The
number of record stream numbers listed depends on
which series is selected.
The N1000, N2000, and N2400 series each have one
recording channel. The N1000's recording channel
can only record one stream, whereas the N2000 can
record two streams on that one channel (dual
recording). The N3000 has ten recording channels,
and each channel can only record one stream.
Channel field Select which channel/stream to record from. This selection is dependent on which Mode you are in
(i.e., which series you are recording from).
In N1000 mode, this field is not applicable.
In N2000 mode, you can select 1 for channel 1 or
dual to record both streams.
In N3000 mode, there will be ten different
channels to select.
Continuous checkbox Enable if you would like the recording to continue
beyond the Time entered.
If Continuous is not enabled, the recording will
simply end after the Time entered has been
reached (see the Time field description earlier in
this chapter).
If Continuous is enabled, the NVR will continue
recording after the Time entered. However, it will
only create a recording matching the designated
length of time. In other words, if Time is set to 10
minutes and the recording continues for 40
minutes, you will only capture the last 10 minutes
of that recording.
Convert checkbox Enable if you want a conversion to take place
automatically once the recording is complete.
Bitrate drop-down Leave the bitrate at the recommended setting or adjust
as needed.
The higher the bitrate, the higher the quality (and the
larger the file) of the conversion. The default is
7500 kbps.
Record button Click to begin recording using the current settings.
Stop Record button Click to end the recording.

AMX SC-N8012 Specifications

General

Brand	AMX
Model	SC-N8012
Category	Controller
Language	English