16
Operation
sensibility) have been changed, end line of result starts and ends with an asterisk (*----*). Each
classification range has a name and a unit, corresponding to the analyte. Result printout can be
in Chinese, too, if it is selected as language.
Typical result printout
Date
Sequence Nr. given by the reader
Patient ID
Values are displayed in conventional
units
Pathological values are marked with an
asterisk (*).
If one or more result classification
limits have been changed, end line of
result starts and ends with an asterisk
(*----*).
Note: The printing on thermal paper may fade during storage, or if it is covered with
transparent tape.
4.6. Memory management
The CombiScan
®
100 stores the last 500 results in memory. With the results entered patient
ID, time and date of measurement are stored as well. In this Menu/Memory sub-menu you can
clear results from memory or transfer stored data to the built in printer or to a device connected
to the serial port (i.e. host computer). To achieve the functions mentioned above follow the
flowchart below.
To Next Page
Loading...
Need help?
General
