18
Operation
System requirements: Hardware:
Pentium III. 300Mhz
Memory: 256 MB RAM
Hard disk: 300 MB HDD
Monitor: 1024*768 color
Software Requirements: Operating Systems:
Windows XP, Windows 2000 or Windows 98
Microsoft Internet Explorer 5.01 or higher
Installation:
1. Install the
CombiScanner data management software on your computer. Please care-
fully read the readme.txt first
2. Switch on the
CombiScan® 100 without connecting it to the host computer
3. Connect the USB cable to the computer and follow the installer to install the USB driver
(you will find the USB driver on CD)
4. Adjust the CombiScan® 100 as follows:
- Menu/Setup/Output/Serial/Protocol to PC
- Menu/Setup/Output/Serial/Speed to 9600
- Menu/Setup/Clock/Display date format to YYYY/MM/DD
- Menu/Setup/Clock/Display clock format to 24h mode
- Menu/Setup/Strip/Unit to Conv or SI
5. Open the CombiScanner data management program and follow the instructions in Help
menu (user’s guide). See also chapter Memory data transfer (see section 4.6.1). Make
sure that the baud rate of selected port of the computer is adjusted to 9600.
To Next Page
Loading...
Need help?
General
