Cassette sipper
14.5 Care and maintenance
Maintenance
Maintenance on the cassette sipper is restricted to replacing the pump tubes (→ Section
“Mounting the tube set”, p. 98).
Pump tubes of other materials or with different inside diameters can be ordered from our
Service Department.
Care
Observe the following advice on device care:
• Avoid any contamination on the sample holder. Wipe off spilt samples or
reagents instantly with an absorbent cloth or tissue. Remove sticking dirt with
a soft cloth moistened with a commercial detergent.
• When you finish using the sipper, fill the flow cell with distilled water. When
the cell dries out, sample residues may remain stuck to the flow cell.
• When you finished working with the sipper, detach the tube cassette from the
pump rollers thus slackening the pump tube. In this way, the elasticity of the
pump tube is maintained longer.
User’s Manual SPECORD 200/205/210/250 – Accessories 07/2005 103
Analytik Jena AG
To Next Page
Loading...
Need help?
General
