Introduction
Safety notes
1.1 Safety notes
Handling of the accessories is subject to the safety instructions given for the SPECORD
®
basic unit (→ User's Manual SPECORD
®
, Section Safety Notes).
For all accessories of the SPECORD
®
Series, the following safety instructions are
applicable:
Intended use!
The SPECORD
®
, including original accessories, may only be used for the applications
described in this manual. The manufacturer cannot assume any liability for any other
application, including that of individual modules or single parts. This also applies to all
service or repair work that is not carried out by authorized service personnel. All
warranty claims shall be forfeited.
Transportation and storage!
Accessories not in use should always be stored in the provided packaging!
For transportation, always use the provided original packaging!
Risk of corrosion!
Do not set up the device near aggressive vapors, e.g. strongly corrosive acid or caustic
vapors! The vapors might corrode the connections, mechanical and optical components
of the device.
Avoid exposing the sample compartment and the accessories to strongly corrosive
substances! For the analysis of such samples, use vapor-tight stoppered cells.
Observe specific instructions!
Accessory-specific instructions are given in the chapter describing its use.
Caution! Contamination!
Never touch any optical mirrors of accessory units!
Additionally, observe the operating instructions and safety notes of any supplied system
components of other manufacturers (e.g. fluid thermostats
6 User’s Manual SPECORD 200/205/210/250 – Accessories 07/2005
Analytik Jena AG
To Next Page
Loading...
Need help?
General
