To do this, connect a mouse to the device and enter the Device Settings Menu > Temperature
Calibration and click on 'Start Manual Calibration'. Then, follow the steps under 'Temperature
Calibration Procedure'.
CALIBRATION OPERATORS
By default, only a user with an Admin role (set in Andalink) can
conduct the Interval and Manual Temperature Calibration.
The calibration operator for these can be changed to a non-Admin (any user) under Advanced
Settings (Temperature) by un-ticking the checkbox for 'Temperature calibration by operator only'.
The calibration operator for Admin Temperature Calibration (on device startup) can also be changed
to any user under Advanced Settings (Temperature).
Refer to Advanced Settings (Temperature) for more information.
10
To Next Page
Loading...
