Manual calibration
If a temperature calibration is needed outside of its regular interval period (e.g. temperatures seem
too high or too low, or is measuring inconsistently), a manual temperature calibration can be
performed.
To do this, just click on the 'Start manual calibration' button.
A calibration operator needs to be physically present to conduct the temperature calibration on the
device. Refer to 'Temperature Calibration Procedure' for instructions.
Show alcohol test reading
Tick to display the Quick and Standard alcohol test results in numerical digits (default setting) e.g.
'0.02%BAC'.
Untick to display alcohol test results as Pass or Fail only.
This setting will apply to test results recorded both on the device and in Andalink.
Note: The Pass limit is 0.00 by default and cannot be changed. Any alcohol reading over 0.00 will be
considered a Fail and sound an alert.
25
To Next Page
Loading...
