DEVICE INSTALLATION
GUIDELINES
● Install the device only indoors, in a covered environment.
● Install the device in a location with sufficient lighting
● Do not use the facial recognition feature under a strong light.
● Do not expose the device to the sun for a prolonged period of time.
● Do not use in locations that are subject to high humidity. Excessive humidity may cause
damage to the device's components.
● Do not install in locations with large temperature fluctuations throughout the day as this may
affect temperature calibration and body temperature results.
● Choose an installation location that has a regular, room temperature - away from direct
sunlight, excessive heat or cold air (e.g. directly facing an air conditioner). Excessively hot or
cold temperatures may affect body temperature readings.
● Use our provided power adapter- connecting it to an improper power source may damage
your equipment and lead to fire and/or damage.
● Keep the camera clean for optimum photos and facial recognition.
● Device should be installed facing directly forward with as little tilt or inclination as possible to
ensure the best body temperature results.
WALL-MOUNTING THE DEVICE
To mount on the wall, use the appropriate
screws (2) and wall anchors (2) for the type
of wall material you are mounting the device
to.
Drill two holes on the wall (depth: 50mm,
distance between: 34mm). Put the wall
anchors inside the hole, and push the screw
inside the wall anchors. Reserve around a
10mm gap from the wall, and fix the device
into place, then hang the device.
7
To Next Page
Loading...
