TEST PROCEDURES
Follow the device's instructions shown in the Notification Area when taking a test.
1. 'Face camera. Keep face inside the frame'
Stand in front of the device, face the camera and position face within the Facial Recognition
Frame shown on the LCD display.
2. Device will analyse the results and display them in the Notification Area.
a. If the temperature reading is above the Body Temperature Limit, an alert will sound
and the test procedure ends.
b. If the temperature reading is below the Body Temperature Limit, the test will proceed
to the next step.
Note: Body Temperature Limit is set under Advanced Settings.
3. Device will then prompt the user to take an alcohol breath test. Follow the instructions in the
Notification Area:
4. Device will analyse the results and display them in the Notification Area along with a voice
alert (if enabled) as “Pass/Fail” “Name/Visitor” “Body temperature” “Alcohol reading” .
Note: Pass/Fail alcohol limit is 0.00 by default and cannot be changed. Any result over 0.00
will be a 'Fail'.
5. Results are synced to Andalink immediately after each test (if device is connected to the
internet).
6. A new user can take another test by repeating from Step 1.
Note: Check ‘Test Delay’ under Advanced Settings menu for the time delay before the next
test can be taken.
12
Quick test mode - Blow fast and hard into the
sampling cup from a distance of 3-5 cm without
touching the sampling cup
Standard test mode - Insert a drinking straw into the
straw adaptor and blow slow and steadily into the
straw
To Next Page
Loading...
