Anilam 3000M - Page 47

CNC Motion Setup/Testing Utility
P/N 70000635B - Index
All rights reserved. Subject to change without notice Index-5
November 2009
rotary encoders, index pulse, 7
S
save amp settings
description, AC systems, 32
select, AC systems, 27
saving, tuning test values, 37
screens
balance test, illustration, AC systems, 26
Balance, illustration, DC systems, 18
CanBus Test, illustration, 29
CNC Motion Setup/Testing, illustration, 2
CNC Resolution Check (ResCheck),
illustration, 5
Signal Gain (SigGain), illustration, DC
systems, 19
signal gain test, illustration, AC systems,
27
Software Options, 1
Tuning Parameters Test Results,
illustration, 37
selecting, an axis, 4
servo amplifier. See amplifier
1 LED, fault conditions, DC systems, 15
1 LED, illustration, DC systems, 14
5 LEDs, fault conditions, table, DC
systems, 15
5 LEDs, illustration, DC systems, 13
failure, DC systems, 18
fault, resetting, DC systems, 17
outputs, balancing, DC systems, 13
servo amplifiers, DC systems, 10
servo drive, test board
description, DC systems, 10
test points and jumpers, listed, DC
systems, 11
setting, signal gain
AC systems, 27
DC systems, 18
SigGain (F7), 3
SigGain (F7), AC systems, 27,
32
SigGain (F7), DC systems, 18
signal gain
adjustment (%), setting, AC systems, 24
setting
AC systems, 27
DC systems, 18
test screen, illustration, AC systems, 27
Signal Gain (SigGain) screen,
illustration, DC systems, 19
single-ended DSP
2
board,
illustration, DC systems, 9
soft keys area, illustration, 2
soft keys, MST, listed, 3
Software Options screen, 1
spindle axis, keypad key,
illustration, 4
starting reference mark,
EverTrack encoder, 6
T
test
board
installation, AC systems, 21
installation, DC systems, 10
servo amplifier, description, AC
systems, 20
command, cancel, 3, 7
points, listed, AC systems, 21
points, listed, DC systems, 11
rigid tapping, description, 30
troubleshooting tools, CNC,
listed, 1
tuning
function values, table, 36
test parameters, listed, 34
test values, to save, 37
to test, 35
Tuning
(F8), 3, 34, 37
Parameters Test Results screen,
illustration, 37
Setup Menu, illustration, 34
U
U-axis, keypad key, illustration, 4
under voltage fault, causes
listed, DC systems, 16
V
velocity loop master gain, AC
systems, 32
X
X-axis, keypad key, illustration, 4
Y
Y-axis, keypad key, illustration, 4
Z
Z-axis, keypad key, illustration, 4