If the transmission is terminated during the radio transmission, the screen will display " FAIL"
Long press the [button] and the screen will display "RESET" to give up tuning
When the auto-tuning mode is not turned on, there is no white scale for 1.0-2.0
ANTUNER only researches ultra-small, portable radio peripherals, and completely develops software and hardware at the bottom
BI3QWQ
http://www.antuner.com
2) Manual tuning mode
If you have finished tuning and want to give up this tuning result, you can long press the [button] to give up tuning, and the screen will display "RESET"
noodle.
If the standing wave and power deviation are detected, please refer to Chapter 3.6 of Advanced Operation to calibrate.
mode, the screen will display "WAIT" waiting for tuning, "TUNE" detecting that the signal is being tuned, and the standing wave value boundary after tuning
If you need to give up tuning during tuning, please stop the radio transmission directly, and the screen will display "FAIL".
2.3 Section.
If the automatic tuning is not enabled or the standing wave is < 1.80, you want to realize the tuning operation, you can long press the [button] to enter the tuning
That's it.
3) Abandon tuning
Machine Translated by Google
To Next Page
Loading...
