Short press the [button] to manually switch between stored results
http://www.antuner.com
ANTUNER only researches ultra-small, portable radio peripherals, and completely develops software and hardware at the bottom
BI3QWQ
If the lowest standing wave is not found in the user stored results during autotune, the temporary stored as will be used, then
storage quantity.
2) Manually switch storage results
1) Default interface
The screen display is shown above as “TEMP*”. Among them, "3.99v" is the current battery voltage, and "88%" is the current remaining battery
This function is to help you quickly switch to the stored relay combination and quickly reduce the standing wave. You can store frequently used
The default interface of user storage mode is 1-9 optional storage, as shown in the above figure, "3" is ÿUSER COUNTÿ
value, where "1" bit is selected, L is the stored inductance value (unit: ÿH ), C is the stored capacitance value (single
quantity.
The tuning result of the frequency or the status of the antenna system can be switched quickly when in use.
If you want to modify the number of stored results, you can refer to Chapter 3.4 [USER COUNT] of the Advanced Manual to adjust the stored results.
Bit: pF ), "88%" is the current remaining power.
The user can short press the button in the launching state to switch the interface.
Machine Translated by Google
To Next Page
