"TEMP*" is displayed when temporarily storing results and no storage number will be selected
http://www.antuner.com
BI3QWQ
ANTUNER only researches ultra-small, portable radio peripherals, and completely develops software and hardware at the bottom
If you want to manually switch between different tuning results, please short press the [button] to complete the switching selection.
If the lowest value between the stored results is less than 1.80 of the standing wave, it will automatically switch to the relay of the current stored results
5) Launch status function interface
3) Manually store tuning results
In the state of the transmitter, the user can launch normally.
If transmitting in storage mode, it will automatically enter the status interface of normal mode, such as bar graph, large font,
If you want to save the tuning result to the specified position number, please long press the [button] and the screen will display "WAIT"
Wait for tuning. When the power signal is detected, the screen will display "TUNE" for automatic tuning. After tuning, if the standing wave <
If the standing wave ÿ 1.80 after cycling through all the stored results, and the auto-tuning function is turned on, the tuner will enter the auto-tuning function.
1.8 is automatically saved to the current number.
automatic tuning status, and store the tuning results in the temporary results, as shown in the figure above when the transmission is stopped; if the automatic tuning is not enabled
For details, refer to manual tuning in chapter 2.4.
In the harmonic state, the tuner will continuously switch between the stored results.
4) Automatically select the lowest standing wave combination from the stored results
Please refer to Chapter 3.4 [USER COUNT] of advanced operations for automatic switching of storage results or modifying the quantity.
If you want to automatically select the combination with the lowest standing wave when transmitting from among multiple stored results, if detected
Automatic tuning function switch, start tuning standing wave 1.80 For modification, refer to Chapter 3.5 of advanced operation [ TUNE AUTO ] and [ TUNE
When the standing wave is ÿ 1.80, it will automatically switch from multiple stored results to find the lowest standing wave.
AUTOSWRÿÿ
Machine Translated by Google
To Next Page
Loading...
