1. Cut off one of the connectors on a standard Cat5e or Cat6 Ethernet cable.
2. Strip off about 40 mm (1½ inch) of the cable jacket and untwist the orange, orange/white,
green and green/white wires. The other wires will not be used.
3. Strip off about 7 mm (¼ inch) of the isolation on each wire.
4. Push the pin spring release next to each socket on the connector and insert the correct
wire end according to Connector, p. 9.
Connect the wires from the power supply in the same way as the Ethernet wiring. Make sure
that polarity is not reversed.
Anybus
®
Wireless Bolt
™
User Manual SCM-1202-007-EN 2.5
To Next Page
Loading...
