The RESET button is located on the bottom of the unit next to the connector.
► Press and hold the button for >10 seconds and then release it to reset to the factory default
settings (when the unit is powered on).
► Press and hold the button during startup to enter Recovery Mode.
Recovery Mode
If the web interface cannot be accessed, the unit can be reset by starting in Recovery Mode
and reinstalling the firmware using Anybus Firmware Manager II, which can be downloaded
from www.anybus.com/support.
Firmware updates should normally be carried out through the web interface.
Recovery Mode should only be used if the unit is unresponsive and the web
interface cannot be accessed.
To Next Page
Loading...
Need help?
General
