Anybus Wireless Bolt User Manual

Configuration 11 (36)
4 Configuration
4.1 General
Anybus Wireless Bolt should normally be configured via the web interface. Parameters can be
set individually or using one of the pre-configured Easy Config modes.
Advanced configuration can be carried out by issuing AT (modem) commands through the web
interface or over a Telnet or RAW TCP connection to port 8080.
The web interface is accessed by pointing a web browser to the IP address of the Wireless Bolt.
The default address is 192.168.0.99. The computer accessing the web interface must be in the
same IP subnet as the Wireless Bolt.
The web interface is designed for the current stable versions of Internet Explorer,
Chrome, Firefox and Safari. Other browsers may not support the full functionality
of the web interface.
Fig. 4 Web interface
Anybus
®
Wireless Bolt
™
User Manual SCM-1202-007-EN 2.5

Anybus Wireless Bolt Specifications

General

Brand	Anybus
Model	Wireless Bolt
Category	Network Hardware
Language	English