Configuration 24 (36)
4.3 Factory Restore
Any one of these actions will restore the factory default settings:
• Holding RESET pressed for >10 seconds and then releasing it
• Executing Easy Config Mode 2
• Clicking on Factory Restore on the System Settings page
• Issuing the AT command AT&F and then restarting the unit
Default Network Settings
IP Assignment Static
IP Address 192.168.0.99
Subnet Mask 255.255.255.0
Default Gateway 192.168.0.99
Default WLAN Settings
Operating Mode Client
Channel Bands 2.4 GHz & 5 GHz
Authentication Mode WPA/WPA2–PSK
Channel Auto
Bridge Mode Layer 3 IP forward
Default Bluetooth Settings
Operating Mode PANU (Client)
Local Name [generated from MAC address]
Security Mode Just works
Default System Settings
Password [empty]
To Next Page
