18
7.2 Sub-menu
7.2.1. In P1.0 mode, press key to enter in sub-menu P1.1 of pH parameter setting, then press
and key to switch among sub-menu: P1.1→P1.2→P1.3→P1.4→P1.5→P1.6, See Diagram–14.
7.2.2. In P2.0 mode, press key to enter in sub-menu P2.1 of conductivity parameter setting, then press
and key to switch among sub-menu: P2.1→P2.2→P2.3→P2.4→P2.5→P2.6→P2.7→ P2.8, See
Diagram – 14.
7.2.3. In P3.0 mode, press key to enter in sub-menu P3.1 of TDS parameter setting, then press
and key to switch among sub-menu: P3.1→P3.2→P3.3→P3.4→P3.5→P3.6→P3.7→P3.8, See
Diagram – 14
Diagram – 14 Main menu and sub-menu of parameter setting
P1.1 Select pH standard solution
P1.2 Select resolution
P1.3 Set stability criteria
P1.4 Set due calibration
P1.5 Check calibration date
P1.6 Restore to factory default setting
P2.1 Select electrode constant
P2.2 Select conductivity standard solution
P2.3 Select standard temp.
P2.4 Adjust temperature compensation factor
P2.5 Adjust TDS coefficient
P2.6 Set due calibration
P2.7 Check calibration date
P2.8 Restore to factory default setting
P3.1 Select temperature unit
P3.2 Select backlight time
P3.3 Adjust timing storage time
P3.4 Adjust date
P3.5 Adjust time
P3.6 Clear stored value
P3.7 Automatic power-off setup
P3.8 Automatic hold setup
Sub-menu of pH parameter setting
Sub-menu of Cond. parameter setting
Sub-menu of basic parameter setting
Main menu of parameter setting
To Next Page
Loading...
Need help?
General
