P3.5. – Adjust time
1. When press key, Hour blinks, then press and Minute blinks.
When the number blinks, press key and key to adjust
time, then press to confirm.
2. After confirm date, press key to enter in P3.6 mode or press
key to return to the measurement mode.
P3.6. – Clear all storage value (No—Yes)
1. When press key, No blinks, then press key to select No—
Yes, press key to confirm. No: not delete, Yes: Delete.
2. After confirm the parameter, press key to enter in mode P3.7 or
press key to return to the measurement mode.
P3.7 – Automatic power-off setup (10→20→30→On)
1. Press key, On blinks, press key to select 10→20→30→On,
press key to confirm.
On – turn off automatic power-off, Time unit is minutes.
2. After confirm the parameter, press key to enter P3.8 or press
to return to the measurement mode.
P3.8 – Set automatic lock-up function（Off→On）
1. Press key, OFF blinks, then press key to select OFF→On,
press key to confirm. Off: not set, On: set (the reading is
automatically locked when stabilizes＞10 seconds.)
2. After confirm the parameter, press key to enter measurement
mode.
To Next Page
Loading...
Need help?
General
