SPECIFICATIONS � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 2
SAFETY INSTRUCTIONS � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 3
CRAWL SPACE DEHUMIDIFICATION � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 3
OPERATING THE DEHUMIDIFIER � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 4
Energy Savings Tips �������������������������������������������������4
MAINTENANCE � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 5
Cleaning the Filter ���������������������������������������������������5
Cleaning the Drain���������������������������������������������������5
PREPARING THE UNIT FOR INSTALLATION � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 6
Installing the Duct Collars ������������������������������������������6
INSTALLING THE DEHUMIDIFIER � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � �7
Dehumidier Location������������������������������������������������7
Leveling and Raising the Dehumidier ����������������������������7
Installing a Condensate Pan Under the Dehumidier ����������7
Installing the Drain���������������������������������������������������8
Installing the Condensate Pump ����������������������������������8
Installing Ductwork ��������������������������������������������������8
WIRING� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 9
Wiring to Remote Controls �����������������������������������������9
Wiring to a Float Switch ���������������������������������������������9
Air Cycling�������������������������������������������������������������9
INSTALLER SETUP� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � �10
Setting Up Remote Control – Crawl Space/Sealed Attic�������10
Setting Up Ventilation/Air Cycling ���������������������������������10
Applying an RH Offset�����������������������������������������������10
STARTING UP THE UNIT AND SEQUENCE OF OPERATION� � � � � � � � � � � � �11
Using the Dehumidier Control Only�������������������������������11
Using a Model 76 as a Remote Control����������������������������11
TROUBLESHOOTING � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � �12
Diagnostic Codes������������������������������������������������12, 13
Troubleshooting Guide����������������������������������������������14
SERVICE PARTS� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � �15
LIMITED WARRANTY�����������������������������������������������������16
Warranty Registration�����������������������������������������������16
TABLE OF CONTENTS
SPECIFICATIONS
Model E070
Unit Weight 56 lbs�
Capacity
80°F, 60% RH Conditions
70 pints per day @ 200 CFM
Power
115 VAC, Single
Phase, 60 Hz
5�8A operating current
Dehumidier Inlet Air Conditions
Dehumidication: 50°F–104°F, 40°F dew point minimum
Ventilation: 40°F–140°F, 0% RH–99% RH (non-condensing)
Filter MERV 8, washable
Airow
External Static Pressure ("WC) Airow (CFM)
0�0 200
0�2 170
0�4 140
NOTE: Rated capacity and current draw measured at 80°F/60% RH inlet conditions at 0.0 external static pressure.
2 English