Aprilaire E070 - Preparing the Unit for Installation; Installing the Duct Collars

A. INLET DUCT COLLAR
B. OUTLET DUCT COLLAR
FIGURE 8: INSTALL DUCT COLLARS
PREPARING THE UNIT FOR INSTALLATION
IMPORTANT: Cut the strap securing the compressor shipping
support bracket and remove the strap and shipping bracket�
See FIGURE 7�
1. Clip off and remove the plastic straps securing the
compressor to the shipping bracket�
2. Remove the two screws securing the shipping bracket to
the housing. Remove and discard the shipping bracket, and
reinstall the two screws in the dehumidier.
INSTALLING THE DUCT COLLARS
Use the screws in the parts bag to attach the duct collars to
the inlet and outlet of the dehumidier.
A
C
B
D
FIGURE 7: PREPARING THE UNIT FOR INSTALLATION
90 -2302
90 -2306
A. PLASTIC STRAP
B. SCREWS
C. SHIPPING BRACKET
D. ON/OFF POWER SWITCH (SELECT MODELS)
90 -2308
A
B
6 English