APT 8512 - Page 42

© Ikonix USA
38
4.4.7 Create Test File – Pulse Mode
1. From the Mode menu press the number
4 key on the keypad to change the Mode to
Pulse. The next screen displayed will reect the
Mode as Pulse, along with a test le name, or
a “No File Loaded” message if no test le has
been loaded in the List Mode:
2. Once the Mode has been set to Pulse, press
any key to drop down the menu bar and press
the number 2 key on the keypad to enter the File
menu:
3. The File screen will be displayed and the
selections on the menu bar will change. If there
are no previously saved test les for Step Mode
the screen of the File menu will display the
selections to Add, Edit or Load a test le on the
menu bar. The Next selection on the menu bar
will not do anything:
4. To start adding a test le press the number 1
key on the keypad to select Add:
5. The next screen will display a eld with a
blinking cursor to enter a name for the le:
6. Use the keypad to enter a name for the test
le (23 character limit):