© Ikonix USA
Table of Contents
1. Introduction 1-4
1.1 Warranty 1
1.2 Glossary 2-3
1.3 Safety Symbols 3-4
1.4 Safety Percaution 4
1.5 Service and Maintence 4
2. Getting Started 5-8
2.1 Unpacking and Inspection 5
2.2 Input Current Consideration 5
2.3 Preparation For Use 5
2.4 Instrument Power Switch 6
2.5 Power Cable 6
2.6 Environmental Conditions 7
2.7 Packaging 8
3. Specifications and Controls 8-19
3.1 Specifications 8-15
3.2 Output Power, Power Factor and Output Current Considerations 15-16
3.3 Instrument Controls 16-19
4. Programming Instructions 20-43
4.1 Powering on the Instrument 20-21
4.2 System 21-23
4.3 Editing System Parameters 23-24
4.4 Mode and File 24-40
4.5 Edit, Copy, Delete, and Load Test File 41-43
5. Perform Test 44-52
5.1 Meter 44
5.2 Manual Mode 44
5.3 List Mode 45
5.4 Step Mode 45
5.4 Pulse Mode 45
5.6 Results 46
5.7 Perform Test Screen Considerations 47
5.8 Error and Failure Messages 48-52
6. Remote PLC 53-55
7. Bus Remote Interface USB/LAN/GPIB (Programmable Option Only) 56-78
7.1 USB Communication Port Configuration 56
7.2 LAN Configuration 57
7.3 SCPI (Standard Commands for Programable Instruments) Basics 57-58
7.4 SCPI Command TREE 59-69
7.5 GPIB Interface 70-71
7.6 GPIB/USB/LAN Interface Sample Command List 72-78
This manual is an interactive PDF. Click each heading below to jump directly to the topic you need. Web addresses are also interactive.
To Next Page
Loading...
Need help?
General
