APT 8520 - SCPI Command TREE

To Next Page

To Previous Page

BASE KEYWORD DESCRIPTION VALUE

OUTPut

:[STATe] <value>

:[STATe]?

Set Output State ON, OFF

MODE <value>

:MODE?

Set Output Mode MANual, LIST, PULSe, STEP

VOLTage:AC <value>

VOLTage:AC?

Set AC Voltage 0.0 – 310.0 VAC

:VOLTage:DC <value>

:VOLTage:DC?

Set DC Voltage 0.0 – 420.0 VDC

:FREQuency <value>

:FREQuency?

Set Frequency 5.0 – 1200 Hz

:CURRent[:LIMit]:HIGH

<value>

:CURRent[:LIMit]:HIGH?

Set Current High Limit 0.05 – 12.50 A*, 0 = OFF

:PROTection:STATe? Query Protection State

FAN_FAIL, SOFT_S, OPP, OCP,

OVP, OPP_PEAK, OCP_PEAK,

OVP_PEAK, INT_TEST_FAIL,

CALIBRATION_ERROR,

Limit_Fail, DD_OCP, DD_UVP,

MCU_FAIL, DA_OTP, PFC_OVP,

AC_LVP, AC_OVP, SET_FAIL,

OUTPUT_SHORT, RCP, RCP_

PEAK, DD_FAIL

:PROTection:CLEar Clear Protection State

7.4 SCPI Command TREE

Program Commands and Companion Queries

These commands are used to modify individual test parameters within each le and/or sequence. Many

of these commands require a parameter value to be included with the command. The companion query

command will read the parameter. The writing of the parameter requires that the unit not be included

with the value and only the numeric value should be included with the command. Also, when the query

commands are sent, the response will not include the unit characters.

7.4.1 - Output Subsystem

Other manuals for APT 8520