APT 8520 - Page 56

© Ikonix USA
52
Code Description
Process to Clear
Press EXIT key Wait 5sec,
Press EXIT key
Reboot. If error
message repeats
contact manufacturer
Contact
Manufacturer
Q-Hi
Displayed when the reactive
power value exceeds the
Q-Hi setting.
•
Q-Lo
Displayed when the reactive
power value stays below the
Q-Lo setting.
•
CF-Hi
Displayed when the crest
factor value exceeds the
CF-Hi setting.
•
CF-Lo
Displayed when the crest
factor value stays below the
CF-Lo setting.
•
VA-Hi
Displayed when the apparent
power value exceeds the
VA-Hi setting.
•
VA-Lo
Displayed when the value of
real power (W) exceeds the
P-Hi setting.
•
Interlock Open
Displayed when the remote
interlock key is not plugged
into the Signal Input port on
the rear panel and the test
button is pressed.
Make sure the Remote Safety Interlock key is plugged into the rear panel
Signal Input port.