APT 8520 - Page 79

© Ikonix USA
75
Command Name Description
BIT 4, 10H,(16) Message Available
BIT 5, 20H,(32) Standard Event (ESB)
BIT 6, 40H,(64) Request Service (MSS)
BIT 7, 80H,(128) Prompt
*SRE <value> Service Request Enable value=0~255
*SRE?
Service Request Enable
Query
0 - 255
*PSC {1|0} Power-On Status
1 = Power-on clear enable registers
0 = Power-on load previous enable registers
*PSC? Power-On Status Query returns value = 0 or 1
*IDN?
Reads the instrument identication string. Company = APT.
*RST
Resets the instrument to original power on conguration. Does not clear Enable register for Standard
Summary Status or Standard Event Registers. Does not clear the output queue. Does not clear the power-
on-status-clear ag. The System parameters that are aected by the *RST command are listed in the
following table:
Item Value
OUTPut[:STATe] OFF
OUTPut:MODE Manual
MANual:FILE:LOAD <none>
MANual:FILE:EDIT <none>
SYSTem:PLC <default value>
SYSTem:POWUP <default value>
SYSTem:ALARm <default value>
SYSTem:OCFold <default value>
SYSTem:SYNChronous <default value>
SYSTem:ANALog <default value>
SYSTem:VOLTage[:AC]:HIGH <default value>
SYSTem:VOLTage[:AC]:LOW <default value>
SYSTem:VOLTage:DC:HIGH <default value>
SYSTem:VOLTage:DC:LOW <default value>
SYSTem:FREQuency:HIGH <default value>
SYSTem:FREQuency:LOW <default value>
METer <default value>