Your
shower was
9:20
Goodbye
Push lever
to power o
39
water turns o
The Q
TM
controller has a proximity sensor, so as you approach or move your
hand towards the Q
TM
controller, the display wakes up and is ready to go.
(You can disable this feature in the Settings menu - see page 17).
STARTING YOUR SHOWER
To activate the Q™ Controller, use the proximity sensor, or touch the power
symbol until the screen wakes up. Then, push and release the Q
TM
lever to
start the shower. The Get Ready screen will appear on the display. After a
moment the target temperature will flash until it is reached. It will then
display the thermostatically controlled temperature.
Wake-up Switching on and o
Remote control
The remote control* can be sited outside
the shower room, or even in your
bedroom, allowing you to start, stop or
divert your shower before you walk in.
Please refer to Remote Control User
Guide for installation and operating
instructions.
*The remote control is an optional extra with Q
TM
. It can operate the shower from up to 10 metres
away, dependent on building materials and construction of the property. For optimal performance,
the Q™ controller should be in direct line of sight with the remote.
To switch o Auto Save Shower go to Settings. (See page 18 for more information).
Please see page 13 for more information about Profiles.
ENDING YOUR SHOWER
Touch the power symbol for approximately 1 second , then push the
Q™ lever to confirm and end the shower.
The proximity sensor detects
any object directly in front, at
approximately 0.5m away
from the controller.
See page 20 for more
proximity sensor features.
SAVING YOUR SHOWER SETTINGS
When your shower ends,
you will be asked if you
want to save the shower.
If you ignore the question,
the Q
TM
controller will
turn o after 5 seconds.
If you select YES, your
0.5 metres
Hello
Warming
39
Get
Ready
39
Push Lever
water turns on
OK
1
YES N
To Next Page
Loading...
Need help?
General
