5
SAFETY PRECAUTIONS
• For optimal performance, this device must be
installed in a well-ventilated environment. If used
indoors, the appliance must be placed, operated, and
m
2
.
• DO NOT install or operate this system before reading
the manufacturer’s instructions.
• This appliance must be installed, commissioned and
serviced by an authorised person in accordance with
all applicable local rules and regulations.
• Removing access cover or water heating system
components will expose 240V wiring and MUST only
be removed by an authorised person.
• If the system’s power supply is damaged, it MUST BE
replaced by an authorised person to avoid a hazard.
Take care not to touch the power connections or
plugs with wet hands.
• This appliance is not intended for use by persons
(including children) with reduced physical, senso-
ry or mental capabilities or lack of experience and
knowledge unless they have been given supervision
or instruction concerning the use of the appliance by
a person responsible for their safety. Children should
be supervised to ensure they DO NOT play with the
appliance.
• For continued safety of this appliance, it must be
installed, operated and maintained per the manufac-
turer’s instructions.
• The electrical connection to this product must be via
a 20A RCD/MCB or RCBO with a test button function.
• This appliance uses R290 (propane) refrigerant, which
must be handled by a refrigeration mechanic with an
appropriate Australian refrigerant handling license.
•
refrigerant is leaked, together with an external ignition
source, there is a possibility of ignition.
•
this appliance.
•
• The appliance should not be stored or transported
an operating gas appliance or an operating electric
heater.).
• Do no pierce or burn the appliance.
• Be aware that the refrigerant may not cause an odour.
• Compliance with AS/NZS 5601 must be observed
while storing the appliance.
• National and state regulations exist for the storage,
transportation and handling of hazardous goods
transported or stored together will be determined by
the appliance regulations.
• If used indoors, the appliance must be placed, op-
least 67m
2
- RAPID/X6 / 47m
2
- DYNAMIC/X8 and any
required ventilation openings clear of obstruction
• Care should be taken not to touch the pipework as it
may be HOT!
• DO NOT place articles on or against this appliance.
•
this appliance.
• DO NOT operate with collectors or covers removed
from this appliance.
• DO NOT activate the heat pump unless the cylinder is
full of water.
• Household electrics must have a reliable earth con-
nection.
• This product must be protected with a residual cur-
rent device of adequate rating.
• Do not interfere with any permanent instructions,
labels or warning plates attached to the external cover
of this heat pump.
•
the mechanical and electrical industry.
• Always comply with local wiring regulations.
• Always engage with a trained professional to relocate
this product after it is installed.
• Maintenance and repair work must only be
• The room’s air extraction opening shall be equal or
-
ed units, it shall be as low as practicable. The air
distance from the air intake openings to prevent recic-
ulation to the space.
•
If the hot water system is not used for two weeks
gas may accumulate in the water heater. To dis-
sipate this gas safely, it is recommended that a
hot tap be turned on for several minutes or until
the discharge of gas ceases. Use a sink, basin, or
bath outlet, but not a dishwasher, clothes wash-
er, or other appliance. During this procedure,
electrical appliance operating nearby. If hydro-
gen is discharged through the tap, it will proba-
bly make an unusual sound as with air escaping.
INSTALLATION & OPERATION. FLAMMABLE MATERIALS.
WARNING ABOUT POSSIBLE DANGERS
To Next Page
Loading...