AQUATECH RAPID/X6 - Commissioning the System; Pre-Start Procedures and Checks

11.1 PRE-START PROCEDURES & CHECKS
• 
trades person, the system is now ready for operation.
• Before turning the system on it is essential that you ensure the heat pump storage tank is

• Air pockets must be bled from the system via a hot water tap. Do not use the PTR valve
alone to bleed the system.
• 
installed from the condensate port to an appropriate drainage point.
• Ensure that your plumber has insulated with high temperature closed cell insulation to
prevent heat loss.
• 
23
COMMISSIONING THE SYSTEM
This appliance is not intended for use by persons (including children) with reduced
physical sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to ensure that they do not play
with the appliance. The appliance shall be installed in accordance with national wiring
regulations.
PRE-CHECK WARNINGS