To Next Page

To Previous Page

1-16

Table 1.6 - Itemized Front Panel Description (continued)

(See Figure 1.2)

____________________________________________________________________________

FIG. 1.2

Row, Col. KEYS FUNCTION

____________________________________________________________________________

9 Keypad Used to enter the desired value for the selected function. After a

function is selected the lowest or last value will be displayed.

Entering the new value on the keypad and pressing the

appropriate units key may change this value. To enter a negative

value, press the minus/backspace key prior to entering the desired

number. Corrections may be made to the displayed value by

successive presses of the minus/backspace key prior to entering

the units.

10 Current Output

Connector

Two pin Lemo connector with a yellow identification ring for the

output of all requested currents.

11 Voltage Output

Connector

Four pin Lemo connector with a red identification ring for the

output of requested voltages.

12 Ventilation Holes Air Inlet

13 Remote Connector Sixteen-pin Lemo connector with a blue identification ring for

connection to the Hand Held Unit. The RESET key should be

pressed before and after connecting or disconnecting the Hand

Held Unit.

14 Aux. Voltage

Connector

A two-pin Lemo connector with an orange identification ring

used only during synchroscope operation. The current cable may

be used with the Aux. Voltage output. During synchroscope

operation the Aux. Voltage and Main Voltage outputs will be the

same amplitude and frequency. The phase angle between the

Aux. Voltage and the Main Voltage outputs is either 0Ê or 180Ê,

selectable by successive presses of the synchroscope key. The

present phase angle is shown on the display.

Arbiter Systems 1040C User Manual

Other manuals for Arbiter Systems 1040C