Arbiter Systems 1040C User Manual

2-32
Table 2.9 - Diagnostic Tests and Error Codes
_____________________________________________________________________________
TEST ERROR DESCRIPTION
##
_____________________________________________________________________________
01 Display and LED Test
No error report (operator views display and LED's for
defects).
02 Control Switch Test
No error report. Operator cued to press Front Panel Buttons.
Test if the button tested is inoperative, if all buttons are
tested and operate, PASS message displayed (pass code is
reported via GPIB if the test was requested over GPIB).
03 Processor Card Test
1 ROM Check Sum Error
2 RAM Check Error
3 Phase Control Test Error
04 ADC Card Test
1 100 mV Reference Error
2 Sample and Hold Test Error
3 A/D Converter Test Error
05 Current Measurement Test
0 Measurement Offset Adjustment Error
1 Reference Measurement Error
2 AC Gain Measurement Error
3 Overload Circuit Test Error
4 1 mA. Range Measurement Error
5 10 mA. Range Measurement Error
6 100 mA. Range Measurement Error
7 1 A. Range Measurement Error
8 10 A. Range Measurement Error
9 Current Amplifier Offset Error
06 Current Source Test
1 Current Generator Attenuator Test Error
2 AC Operation Failure

Arbiter Systems 1040C Specifications

General

Brand	Arbiter Systems
Model	1040C
Category	Test Equipment
Language	English